Sinumerik CYCLE83 Deep hole peck drilling cycle .

                            Sinumerik CYCLE 83 used for deep hole drilling . We also known as deep hole peck drilling  cycle 

CYCLE83 (RTP, RFP, SDIS, DP, DPR, FDEP, FDPR, DAM, DTB, DTS, FRF,

                                                              VARI, _AXN, _MDEP, _VRT, _DTD, _DIS1)

            
                                               Where, RTP- Retraction plane (absolute)
                                                           RFP- Reference plane (absolute)
                                                           SDIS- Safety distance 
                                                           DP- Final drilling depth (absolute)
                                                           DPR- Final drilling depth related to reference plane .
                                                           FDEP- First drilling depth (absolute)
                                                           FDPR- First drilling depth relative to reference plane 
                                                           DAM- Amount of degression
                                                           DTB- Dwell time at final
                                                           DTS- Dwell time at starting point for swarf removal
                                                           FRF- First drilling depth feed rate factor . Range value                                                                                 0.001.....1
                                                          VARI- Machining type : (chip break =0 , swarf removal= 1)
                                                          AXN- Selection of axis Z=3
                                                          MDEP- Minimum drilling depth .
                                                          VRT - _____ (skip)
                                                          DTD- _____ (skip)
                                                          DIS1-_____(skip)

Deep-hole drilling with chip removal (VARI=1):            More examples..........!!!!

● Approach of reference plane shifted by the amount of the safety clearance with G00

● Traversing to the first drilling depth with G01, whereby the feedrate results from the
feedrate programmed during the cycle call that is compensated with the FRF (feedrate
factor) parameter.

● Execution of dwell time at final drilling depth (DTB parameter).

● Retraction to the reference plane shifted by the amount of the safety clearance with G00
for chip removal.

● Execute dwell time at starting point (DTS parameter).

● Approach of the last drilling depth reached, minus the limit distance, programmable or
calculated within the cycle, with G00.

● Traversing to next drilling depth with G01 (motion sequence is continued until the final
drilling depth is reached).

● Retraction to the retraction plane with G00.

Deep-hole drilling with chip breakage (VARI=0):         More examples..........!!!!


● Approach of reference plane shifted by the amount of the safety clearance with G00

● Traversing to the first drilling depth with G01, whereby the feedrate results from the
feedrate programmed during the cycle call that is compensated with the FRF (feedrate
factor) parameter.

● Execution of dwell time at final drilling depth (DTB parameter).

● Variable retraction (Parameter _VRT) from the current drilling depth with G01 and the
feedrate programmed in the calling program (for chip breakage).

● Traversing to next drilling depth with G01 and the programmed feedrate (motion sequence
is continued until the final drilling depth is reached).


● Retraction to the retraction plane with G00.
Sinumerik CYCLE83 Deep hole peck drilling cycle . Sinumerik CYCLE83 Deep hole peck drilling cycle . Reviewed by HARSHAL DHAWAS on September 02, 2018 Rating: 5
Powered by Blogger.