Fanuc G82 counter boring cycle II Drilling cycle II

                                     G82 cycle is used for normal drilling . Cutting feed is performed to the bottom of the hole .At the bottom , a dwell is performed , the tool is retracted. This cycle is used to drill hole more accurately with respect to depth.

G82 X_ Y_ Z_ R_  P_ F_ K_;
                    Where , XY- Position of hole
                                  Z-  Depth of operation performe
                                  R-  R plane position
                                  P- Dwell time when tool reach at bottom
                                  F- cutting feed rate 
                                  K- no of times operation repeats.
Operation :- First tool positioning at XY axis , after the tool rapidly traverse up to R-plane level , after that tool is start drilling operation . When the bottom of the tool has been reached, a dwell is performed. Then tool is retracted rapidly.

N10   M06 T04 ;
N20   G90 G80 G17 G00 G54 X0 Y0 ;
N30   G43 Z100 H4 ;
N40   M03 S1500 ;
N50   M07 ;
N60   G99 G82 X20 Y20 Z-10 R5  P1000 F120  ;
N70   X50 Y20 ;
N80   G98 G80 G00 Z100 ;
N90   M05 M09 M30 ;
                                                                       More examples..........!!!!

N10- Tool change command , select tool no. 4
N20- Absolute co-ordinate command , cancel canned cycle command , selection of  XY plane, rapid command, work coordinate for tool positioning at  X0 and Y0.
N30- Tool height offset compensation command , where tool is 100 along Z axis , tool hight code H4.
N40- Spindle on clockwise , speed is 1500 rpm .
N50- Coolant ON .
N60- Return to R-plane in canned cycle , counter drilling command ,first drilling position is X20 and Y20 Depth of drilling is 10 , R- plane distance is 5 ,dwell time is 1 sec ,   feed rate is 120. 
N70- Second drill position where X 50 and Y20 and drilling depth is 10.
N80-Tool return initial position , cancel canned cycle , rapid command , where tool along Z axis is 100 .
N90-Spindle off , coolant off, Main program end . 
Fanuc G82 counter boring cycle II Drilling cycle II Fanuc G82 counter boring cycle II Drilling cycle II Reviewed by HARSHAL DHAWAS on August 24, 2018 Rating: 5
Powered by Blogger.